ASTM-D3296 › Historical Revision Information
Standard Specification for FEP-Fluorocarbon Tube
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 The tubing is intended for electrical, mechanical, chemical, and medical applications manufactured from extrusion resins made from the copolymer of tetrafluoroethylene and hexafluoropropylene (FEP-fluorocarbon). This specification is for virgin material only and does not address recycled material as it is not appropriate for FEP tubing.
Note 1—Abbreviations are in accordance with Terminology D 1600.
Note 2—There is no similar ISO standard.
1.2 The values stated in SI units are to be regarded as the standard. The values given in brackets are for information only.
1.3 The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
extruded material; FEP extruded tubing; fluorocarbon tubing; fluoropolymers; melt-processible fluorocarbon polymer; polytetrafluoroethylene copolymers; thin-walled tubing; ICS Number Code 23.040.20 (Plastic pipes)
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3296-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Nov. 1, 2003
Document Type
Specification
Page Count
4 pages
Committee Number
D20.15