Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination of the resistance to abrasion of fabrics coated with rubber or plastics. The abrasion is measured by mass loss.

1.2 Two methods are covered as follows:

1.2.1 Method A -Abrasion to end point (Sections 8 to 10).

1.2.2 Method B -Abrasion for a specified number of cycles with determination of loss in mass (Sections 11 to 13).

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

abrasion; coated fabr; mass loss; plast; rubber; ICS Number Code 59.080.40 (Coated fabr)

To find similar documents by ASTM Volume:

09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)

09.02 (Rubber Products, Industrial - Specifications and Related Test Methods; Gaskets; Tires)

To find similar documents by classification:

59.080.40 (Coated fabrics)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.