ASTM-D3404 › Historical Revision Information
Standard Guide for Measuring Matric Potential in Vadose Zone Using Tensiometers (Withdrawn 2024)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This guide covers the measurement of matric potential in the vadose zone using tensiometers. The theoretical and practical considerations pertaining to successful onsite use of commercial and fabricated tensiometers are described. Measurement theory and onsite objectives are used to develop guidelines for tensiometer selection, installation, and operation.
1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Civil-engineering projects; Field testing-ground water/aquifers; Flow and flow rate-soil/rock; Hazardous waste sites; Irrigation management; Matric potential; Recharge studies; Soil-water tension; Tensiometer; Vadose zone; Water; Water flux; matric potential in the vadose zone, using commercial/fabricated; tensiometers, guide; ICS Number Code 07.060 (Geology. Meteorology. Hydrology)
To find similar documents by ASTM Volume:
04.08 (Soil and Rock (I): D420 - D5876)
To find similar documents by classification:
07.060 (Geology. Meteorology. Hydrology)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3404
Revision Level
WITHDRAWN
Status
Cancelled
Modification Type
Reapproval
Publication Date
Jan. 4, 2024
Document Type
Guide
Committee Number
D18.21