ASTM-D3518 › Historical Revision Information
Standard Test Method for In-Plane Shear Response of Polymer Matrix Composite Materials by Tensile Test of a ±45 degrees Laminate
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice determines the in-plane shear response of polymer matrix composite materials reinforced by high-modulus fibers. The composite material form is limited to a continuous-fiber reinforced composite +45° laminate capable of being tension tested in the laminate chi-direction.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
Keywords
composite materials; shear modulus; shear properties; shear strength
To find similar documents by ASTM Volume:
15.03 (Space Simulation; Aerospace and Aircraft; Composite Materials)
To find similar documents by classification:
49.025.40 (Rubber and plastics)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3518-76(1982)
Revision Level
1976 R82 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Aug. 27, 1976
Document Type
Test Method
Page Count
6 pages
Committee Number
D30.04