ASTM-D3763 › Historical Revision Information
Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of puncture properties of plastics, including films, over a range of test velocities.
1.2 Test data obtained by this test method is relevant and appropriate for use in engineering design.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1-This specification does not closely conform to ISO 6603.2. The only similarity between the two tests is that they are both instrumented impact tests. The differences in striker, fixture, and specimen geometries and in test velocity can produce significantly different test results.
Keywords
falling weight; impact testing; plast; puncture properties; ICS Number Code 83.080.01 (Plast in general)
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3763-97
Revision Level
1997 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 10, 1997
Document Type
Test Method
Page Count
7 pages
Committee Number
D20.10