ASTM-D3763 › Historical Revision Information
Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of puncture properties of rigid plastics over a range of test velocities.
1.2 Test data obtained by this test method are relevant and appropriate for use in engineering design.
1.3 The values stated in SI units are to be regarded as standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—This specification does not closely conform to ISO 6603.2. The only similarity between the two tests is that they are both instrumented impact tests. The differences in striker, fixture, and specimen geometries and in test velocity can produce significantly different test results.
Significance and Use
This test method is designed to provide load versus deformation response of plastics under essentially multiaxial deformation conditions at impact velocities. This test method further provides a measure of the rate sensitivity of the material to impact.
Multiaxial impact response, while partly dependent on thickness, does not necessarily have a linear correlation with specimen thickness. Therefore, results should be compared only for specimens of essentially the same thickness, unless specific responses versus thickness formulae have been established for the material.
For many materials, there may be a specification that requires the use of this test method, but with some procedural modifications that take precedence when adhering to the specification. Therefore, it is advisable to refer to that material specification before using this test method. Table 1 of Classification System D 4000
Keywords
falling weight; impact testing; plastics; puncture properties; Velocity; Deformation--plastics; Falling weight test; High speed puncture properties; Impact resistance--plastics; Impact testing--plastics; Loading tests--plastics; Minimum instrumentation requirements; Multiaxial impact testing; Puncture; Rigid plastics; ICS Number Code 83.080.01 (Plastics in general)
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3763-08
Revision Level
2008 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Aug. 1, 2008
Document Type
Test Method
Page Count
9 pages
Committee Number
D20.10