Document Center is acquired by Nimonik

Scope

1.1 This practice covers the manner in which the various results of examination and analysis to determine the composition of deposits formed from water for subsurface injection are to be reported.

1.2 All analyses shall be made in accordance with the test methods of ASTM, unless otherwise specified.

Note 1—While reporting of inorganic constituents in water-formed deposits as specified in Practice D 933 is sufficient for certain industries, this practice provides for the reporting of organic and biological materials as well as inorganic constituents.

Note 2—Consistent with practices in industries where subsurface injection of water is practiced, reporting includes specifying of inorganic constituents as probable molecular combinations of the species for which analyses are performed.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This practice sets down the manner in which data obtained from other test methods should be reported. This is done in an effort to standardize the report form used.

Keywords

data reporting; deposits; subsurface injection; water injection; Data analysis--water; Deposits/deposition; Microbiological water quality; Subsurface injection; Surface water; Waterborne sediment; Water-formed deposits; Water injection

To find similar documents by ASTM Volume:

11.02 (Water (II))

To find similar documents by classification:

13.060.50 (Examination of water for chemical substances)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.