Document Center is acquired by Nimonik

Scope

1.1 This guide is an integral part of a series of standards that are being prepared on the in situ determination of hydraulic properties of aquifer systems by single- or multiple-well tests. This guide provides guidance for development of a conceptual model of a field site and selection of an analytical test method for determination of hydraulic properties. This guide does not establish a fixed procedure for determination of hydrologic properties.

1.2 The values stated in SI units are to be regarded as standard.

1.3 Limitations -Well techniques have limitations in the determination of hydraulic properties of ground-water flow systems. These limitations are related primarily to the simplifying assumptions that are implicit in each test method. The response of an aquifer system to stress is not unique; therefore, the system must be known sufficiently to select the proper analytical method.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Aquifers; Coefficient of storage; Confined aquifers; Control wells; Discharging wells; Field testing-ground water/aquifers; Hydraulic conductivity; Observation wells; Piezometers; Storativity; Transmissivity and reflectivity; ICS Number Code 13.060.10 (Water of natural resources)

To find similar documents by ASTM Volume:

04.08 (Soil and Rock (I): D420 - D5876)

To find similar documents by classification:

13.060.10 (Water of natural resources)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.