ASTM-D4132 › Historical Revision Information
Standard Practice for Sampling Phytoplankton with Conical Tow Nets
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the procedures for obtaining qualitative samples of a phytoplankton community by use of conical tow nets. Nets will not retain all phytoplankton taxa; for example, nannoplankton and ultraplankton generally will pass through a net.
1.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
The advantages of conical tow nets are as follows:
3.1.1 They are relatively inexpensive, easy to construct, and highly versatile in a variety of surface waters.
3.1.2 They can be used from a small powered boat with a minimum of auxiliary equipment.
3.1.3 They provide a simple means by which to collect qualitative samples of macro- and micro-plankton.
3.1.4 They can be adapted with a flowmeter to collect semiquantitative samples of macro- and micro-plankton.
The disadvantages of conical tow nets are as follows:
3.2.1 They are effective only where drawn through a stratum of water having considerable thickness. They are not suitable for collecting samples from a small or restricted region.
3.2.2 They are not suitable for collections in very shallow water.
3.2.3 They collect only qualitative samples, or semiquantitative samples when used with a flowmeter.
3.2.4 Clogging of the net by extraneous materials, such as floating vascular plants or debris can cause erroneous results.
3.2.5 If discrete depths are sampled using a horizontal tow, the sample can be contaminated with organisms from other depths during the deployment and retrieval of the samples.
There are several special considerations that shall be observed when using conical tow nets. They are as follows:
3.3.1 The conical net samplers are designed to be towed at speeds less than 3 knots; however, greater speeds have been used for the larger nets with a concomitant increase in capture.
3.3.2 Although there is a tendency to use the smallest mesh size available, there is the liability of small mesh sizes reducing the collection efficiency and increasing equipment failure through tearing.
3.3.3 If discrete depth samples are required, an opening and closing net device should be installed on the sampler.
3.3.4 The nets should be washed frequently and inspected for pin-size holes, tears, net deterioration, and other anomalies.
3.3.5 Following use, wet nets should be suspended full length in air and in subdued light and allowed to dry.
To find similar documents by ASTM Volume:
11.06 (Biological Effects and Environmental Fate; Biotechnology)
To find similar documents by classification:
07.100.20 (Microbiology of water Examination of biological properties of water, see 13.060.70)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4132-82(2004)
Revision Level
1982 R04 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Jan. 1, 2004
Document Type
Practice
Page Count
2 pages
Committee Number
E47.01