ASTM-D4630 › Historical Revision Information
Standard Test Method for Determining Transmissivity and Storage Coefficient of Low-Permeability Rocks by In Situ Measurements Using the Constant Head Injection Test
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers a field procedure for determining the transmissivity and storativity of geological formations having permeabilities lower than 10 -3 [mu]m (1 millidarcy) using constant head injection.
1.2 The transmissivity and storativity values determined by this test method provide a good approximation of the capacity of the zone of interest to transmit water, if the test intervals are representative of the entire zone and the surrounding rock is fully water-saturated.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Borehole drilling; Constant head testing; Discontinuities-rock; Fault zones; Field testing-rock; Flow and flow rate-soil/rock; Permeability-soil/rock; Pressure testing-rock; Rock; Saturation; Viscosity-rock; Water; Water saturation
To find similar documents by ASTM Volume:
04.08 (Soil and Rock (I): D420 - D5876)
To find similar documents by classification:
07.060 (Geology. Meteorology. Hydrology)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4630-96
Revision Level
1996 EDITION
Status
Superseded
Modification Type
Revision with Title Change
Publication Date
Oct. 10, 1996
Document Type
Test Method
Page Count
6 pages
Committee Number
D18.21