Document Center is acquired by Nimonik

Scope

1.1 These test methods determine the total chlorine content of the mixed isomers of toluene diisocyanate (TDI). The difference between the total chlorine content and the hydrolyzable chlorine content (see Test Method D4663) is a measure of the amount of o-dichlorobenzene and other ring-substituted chlorinated products that are present. Both procedures are applicable to a variety of organic compounds but the amount of sample used may have to be varied. (See Note 1.)

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements, see Notes 2, 4, 5, 6, 10, and Section 12.1.

Keywords

aromatic isocyanates; chlorine; isocyanates; oxygen; polyurethane raw materials; Schoniger; titration; toluene diisocyanate; ICS Number Code 83.080.10 (Thermosetting materials)

To find similar documents by ASTM Volume:

08.02 (Plastics (II): D3222 - D5083)

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

83.080.10 (Thermosetting materials Including ebonite Silicones, see 71.100.55)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.