ASTM-D4662 › Historical Revision Information
Standard Test Methods for Polyurethane Raw Materials: Determination of Acid and Alkalinity Numbers of Polyols
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods measure the acidic and basic constituents in polyols and other materials of high acidity or alkalinity that are soluble in mixtures of toluene and ethyl alcohol. These test methods do not apply to polyethers. (See Note 1.)
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1: There is no known ISO equivalent to this standard.
Significance and Use
5.1 These test methods are suitable for quality control, as specification tests, and for research. The acid and alkalinity numbers indicate the extent of a reaction with acids. The results are measures of batch-to-batch uniformity and are typically used as correction factors in calculating hydroxyl number.
Keywords
acidity; acid number; alkalinity number; polyols; acidity; acid number; alkalinity number; polyols;
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.080.20 (Thermoplastic materials)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4662-15
Revision Level
2015 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 1, 2015
Document Type
Test Method
Page Count
3 pages
Committee Number
D20.22