ASTM-D483 › Historical Revision Information
Standard Test Method for Unsulfonated Residue of Petroleum Plant Spray Oils
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of unsulfonated residue in plant spray oils of petroleum origin and applies only to the petroleum oil content. It provides a measure of the degree of refinement of plant spray oils by determining the extent to which the oil is attacked by 98.61% sulfuric acid under closely standardized conditions. Since the relationship between unsulfonated residue and the actual composition of the oil is not known, this test method should be applied only for measuring the degree of refinement and not for the determination of aromatics or olefins, or both.
1.2 The values stated in inch-pound units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
petroleum plant spray oils; unsulfonated residue; ICS Number Code 75.080 (Petroleum products in general)
To find similar documents by ASTM Volume:
05.01 (Petroleum Products and Lubricants (I): D56 - D3710)
To find similar documents by classification:
75.080 (Petroleum products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D483-86e1
Revision Level
1986(E1) EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Nov. 1, 1988
Document Type
Test Method
Page Count
5 pages
Committee Number
D02.06