ASTM-D4843 › Historical Revision Information
Standard Test Method for Wetting and Drying Test of Solid Wastes
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers procedures for determining material losses produced by repeated wetting and drying of solid waste specimens. It also covers the visual observation of the disintegration of solid specimens.
1.2 This test method intends that the material used in the procedure be physically, chemically, and biologically representative; hence it does not address problems as a result of the inhomogeneity of specimens.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
isintegration rate; material losses from repeated wetting/drying of solid wastes, test, ; Municipal solid waste (MSW); material losses from repeated wetting/dryingof solid wastes, test, ; Refuse-derived fuel (RDF); material losses from repeated wetting/drying of solid wastes, test, ; Visual examination-waste materials; material losses from repeated wetting/drying of solid wastes, test, ; Wetting-and-drying; material losses from repeated wetting/drying of solidwastes, test, ;
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4843-88
Revision Level
1988 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
July 29, 1988
Document Type
Test Method
Page Count
4 pages
Committee Number
D34.01.06