Document Center is acquired by Nimonik

Scope

1.1 This test method covers procedures for determining material losses produced by repeated wetting and drying of solid waste specimens. It also covers the visual observation of the disintegration of solid specimens.

1.2 This test method intends that the material used in the procedure be physically, chemically, and biologically representative; hence it does not address problems as a result of the inhomogeneity of specimens.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method is intended for the evaluation of the wetting and drying resistance of monolithic, solid, solidified/stabilized wastes under the testing conditions of this test method.

This test method may be used for the comparison of wetting and drying resistance of wastes.

Data tabulated in Table 1, Table 2, and Table 3 may be used to observe irregularities caused by inhomogeneity of specimens and/or comparison of mass loss-cycle relations of different wastes, as well as to measure method-related mass losses such as matrix dissolution.

Keywords

wetting test; drying test; solid wastes

To find similar documents by ASTM Volume:

11.04 (Waste Management)

To find similar documents by classification:

13.030.10 (Solid wastes)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.