ASTM-D4942 › Historical Revision Information
Standard Test Methods for Water Pickup of Lithographic Printing Inks and Vehicles in a Laboratory Mixer
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover two procedures for determining the amount of water picked up by lithographic printing inks in a laboratory mixer.
1.2 Test Method A covers single-point water pickup; Test Method B covers the rate of water pickup. Both test methods are applicable to any printing ink and vehicle intended for the lithographic printing process.
1.3 This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
lithographic printing inks; printing inks; inks; vehicles; water pickup; water content; emulsification; fountain solution; mixers; ICS Number Code 87.080 (Inks. Printing inks)
To find similar documents by ASTM Volume:
06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)
To find similar documents by classification:
87.080 (Inks. Printing inks Materials for graphic technology, see 37.100.20)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4942-89(2001)
Revision Level
1989 R01 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
April 28, 1989
Document Type
Test Method
Page Count
3 pages
Committee Number
D01.56