ASTM-D4984 Historical Revision Information
Standard Test Method for Carbon Dioxide in Natural Gas Using Length-of-Stain Detector Tubes

ASTM-D4984 - 2006 R11 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Carbon Dioxide in Natural Gas Using Length-of-Stain Detector Tubes
ORDER

Scope

1.1 This test method covers a rapid and simple field determination of carbon dioxide in natural gas pipelines. Available detector tubes provide a total measuring range of 100 ppm (parts per million) up to 60 % by volume, although the majority of applications will be on the lower end of this range (that is, under 5 %). At least one manufacturer provides a special kit for measurements from 10 to 100 % CO2, but the normal 100-cc hand pump is not used. See Note 1.

Note 1—High-range carbon dioxide detector tubes will have measuring ranges in percent (%) CO2, and low-range tubes will be in parts per million (ppm). To convert percent to ppm, multiply by 10 000 (1 % = 10 000 ppm).

1.2 The values stated in SI units are regarded as standard. The inch-pound units in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

The measurement of carbon dioxide in natural gas is important, because of the gas quality specifications, the corrosive nature of carbon dioxide on pipeline materials, and the affects of carbon dioxide on utilization equipment.

This test method provides inexpensive field screening of carbon dioxide. The system design is such that it may be used by nontechnical personnel with a minimum of proper training.

Keywords

gaseous fuels; natural gas ; Carbon dioxide content--natural gas; Field testing--natural gas; Length-of-stain detector tubes; Natural gas service systems; ICS Number Code 75.160.30 (Gaseous fuels)

To find similar documents by ASTM Volume:

05.06 (Gaseous Fuels; Coal and Coke)

To find similar documents by classification:

75.160.30 (Gaseous fuels Including liquefied petroleum gases Hydrogen, see 71.100.20 Natural gas, see 75.060)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D4984-06(2011)

Revision Level

2006 R11 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

March 15, 2012

Document Type

Test Method

Page Count

3 pages

Committee Number

D03.07