ASTM-D5013 › Historical Revision Information
Standard Practices for Sampling Wastes from Pipes and Other Point Discharges
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 Those practices provide guidance for obtaining samples of waste at discharge points from pipes, sluiceways, conduits, and conveyor belts. The following are included:
Sections Practice A---Liquid or Slurry Discharges 7 through 9 Practice B---Solid or Semisolid Discharges 10 through 121.2 These practices are intended for situations in which there are no other applicable ASTM sampling methods (see Practices
1.3 These practices do not address flow and time-proportional samplers and other automatic sampling devices.
1.4 Samples are taken from a flowing waste stream or moving waste mass and, therefore, are descriptive only within a certain period. The length of the period for which a sample is descriptive will depend on the sampling frequency and compositing scheme.
1.5 It is recommended that these practices be used in conjunction with ASTM Guide D4687.
1.6 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 5 for more information.
Keywords
Conduits; Conveyor belts; Discharge; Drainage materials/systems; Drainage systems-land drainage; Drainage systems-sewer/drain pipe; Liquids-waste; Sampling-waste; Semi-solid materials; Sluiceways; Slurries; Solid phase materials-waste; Wastewater testing/treatment; sampling wastes from pipes/other point discharges, practices; ICS Number Code 13.030.01 (Wastes in general)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5013-89
Revision Level
1989 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Nov. 24, 1989
Document Type
Practice
Page Count
3 pages
Committee Number
D34.01.02