Document Center is acquired by Nimonik

Scope

1.1 This test method covers determination of curing parameters of pultrusions resins by differential scanning calorimetry.

1.2 This test method is applicable to pultrusion resin solutions with adequate initiator(s).

1.3 The normal operating temperature range is from 0 to 200°C.

Note 1-Resin systems which do not form an adequate baseline are not covered by this test method.

1.4 Computer or electronic based instruments or data treatment equivalent to this practice may also be used.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Note 1.

Note 2- There is no similar or equivalent ISO standard.

Keywords

Calorimeter-differential scanning (DSC); Curing characterist-plast; Pultrusion resin; Resins; Thermal analysis; ICS Number Code 83.080.10 (Thermosetting materials)

To find similar documents by ASTM Volume:

08.02 (Plastics (II): D3222 - D5083)

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

83.080.10 (Thermosetting materials Including ebonite Silicones, see 71.100.55)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.