ASTM-D5245 › Historical Revision Information
Standard Practice for Cleaning Laboratory Glassware, Plasticware, and Equipment Used in Microbiological Analyses
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 In microbiology, clean glassware is crucial to ensure valid results. Previously used or new glassware must be thoroughly cleaned. Laboratory ware and equipment that are not chemically clean are responsible for considerable losses in personnel time and supplies in many laboratories. These losses may occur as down time when experiments clearly have been adversely affected and as invalid data that are often attributed to experimental error. Chemical contaminants that adversely affect experimental results are not always easily detected. This practice describes the procedures for producing chemically clean glassware.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This practice does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautions, see Section 5, 7.3.1, and Notes 1 and 2.
Keywords
acid cleaning; alkali-cleaning; cleaning glassware; cleaning plasticware; glasswasher; laboratory waste disposal; ICS Number Code 07.100.01 (Microbiology in general)
To find similar documents by ASTM Volume:
To find similar documents by classification:
07.100.01 (Microbiology in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5245-92(1998)
Revision Level
1992 R98 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 15, 1992
Document Type
Practice
Page Count
5 pages
Committee Number
D19.24