ASTM-D5303 › Historical Revision Information
Standard Test Method for Trace Carbonyl Sulfide in Propylene by Gas Chromatography
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of traces of carbonyl sulfide (COS) in propylene. It is applicable to COS concentrations from 0.5 to 4.0 mg/kg (parts per million by mass). See Note 1.
Note 1—The lower limit of this test method is believed to be below 0.1 mg/kg, depending on sample size and sensitivity of the instrumentation being used. However, the cooperative testing program was conducted in the 0.5 to 4.0 range due to limitations in preparing commercial test mixtures.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 8.
Keywords
Carbonyl sulfide (COS); Chromatography-gas (petroleum products); Flame photometric detector; Photometry; Propylene; Trace carbonyl sulfide (COS); carbonyl sulfide (trace)-propylene, by gas chromatography, test; ICS Number Code 71.080.10 (Aliphatic hydrocarbons)
To find similar documents by ASTM Volume:
05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)
To find similar documents by classification:
71.080.10 (Aliphatic hydrocarbons)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5303-92(2002)e1
Revision Level
1992 R02(E1) EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
March 1, 2003
Document Type
Test Method
Page Count
6 pages
Committee Number
D02.D0.03