ASTM-D5331 › Historical Revision Information
Standard Test Method for Evaluation of Mechanical Handling of Unitized Loads Secured with Stretch Wrap Films
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers evaluation and comparison of the ability of unitizing films to survive various methods of mechanical handling.
1.2 The test method described is applicable to common means of material handling, including the following: forklift, push/pull, clamp truck, crane, and spade lift-type handling systems.
1.3 The test levels may be varied to reflect known levels of intensity accurately for the specific unit load under testing.
1.4 The methodology of performing the mechanical handling tests is described in detail in Methods D1083. This test method will describe only sample preparation and evaluation in the special case of evaluating the performance of stretch film for load unitizing.
1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
mechanical handling; stretch wrap materials; thin films; unitized loads
To find similar documents by ASTM Volume:
15.10 (Packaging; Flexible Barrier Packaging)
To find similar documents by classification:
55.220 (Storing. Warehousing Storage equipment, see 53.080)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5331-98
Revision Level
1998 EDITION
Status
Superseded
Modification Type
New
Publication Date
April 10, 1998
Document Type
Test Method
Page Count
2 pages
Committee Number
D10.25