ASTM-D5346 › Historical Revision Information
Standard Test Method for Determination of the Pour Point of Petroleum Oil Used in Fatliquors and Softening Compounds
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the pour point of petroleum oils used in the softening and stuffing of leather, and in the manufacture of fatliquors and other softening and stuffing compounds. This test method was derived from Test Method D97 and ALCA Method H-18.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
3.1 This test method is intended to determine the pour point of petroleum oils used in the softening and stuffing of leather, as well as those used in the manufacture of products for such purpose. The pour point of petroleum oils is measured for the purpose of quality assurance.
Keywords
fatliquors; leather; petroleum oil pour point; softening and stuffing compounds ;
To find similar documents by ASTM Volume:
15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)
To find similar documents by classification:
75.080 (Petroleum products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5346-17
Revision Level
2017 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 1, 2017
Document Type
Test Method
Page Count
4 pages
Committee Number
D31.08