ASTM-D5711 › Standard Test Method for Determining the Adherent Coating on Coarse Aggregates (Withdrawn 2012)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method is used to determine the adherent coating on coarse aggregate (aggregate retained on the 2.36-mm (No. 8) sieve) for the following purposes:
1.1.1 Preliminary investigation of mineral aggregate sources.
1.1.2 Control of mineral aggregates used in hot mix asphalt (HMA) pavements, seal coats, cover coats, surface treatments, cold mix asphalt, and portland cement concrete at the source of supply.
1.1.3 Control of mineral aggregate processing requirements.
1.1.4 Acceptance or rejection of aggregates based on adherent coating.
1.2 The values shown in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1—This test method is modeled after Federal Land Highways T 512-94.
Significance and Use
This test method assigns a measurable value to the amount of fine material adhering to the aggregate.
Keywords
adherent coating; coarse aggregate; sieve analysis; ICS Number Code 19.120 (Particle size analysis. Sieving)
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
19.120 (Particle size analysis. Sieving Including test sieves and porosimetry)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5711-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Withdrawn
Publication Date
July 10, 2003
Document Type
Test Method
Page Count
2 pages
Committee Number
D04.51