ASTM-D575 › Standard Test Methods for Rubber Properties in Compression
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover two test procedures for determining the compression-deflection characteristics of rubber compounds other than those usually classified as hard rubber and sponge rubber.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
4.1 These test methods are useful in comparing stiffness of rubber materials in compression. They can be used by rubber technologists to aid in development of materials for compressive applications.
Keywords
compression; compression deflection characteristics; compression test at specified deflection; compression test at specified force; compression testing of rubber; compressive force; constant force; deflection; hysterisis; rubber in compression ;; ICS Number Code 83.060 (Rubber)
To find similar documents by ASTM Volume:
09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
IPC-A-610Acceptability of Electronic Assemblies (Hardcopy format)
IPC-A-600
Acceptability of Printed Boards
ASTM-D2240
Standard Test Method for Rubber Property—Durometer Hardness
Document Number
ASTM-D575-91(2018)
Revision Level
1991 R18 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
June 1, 2018
Document Type
Test Method
Page Count
4 pages
Committee Number
D11.10