ASTM-D5761 › Historical Revision Information
Standard Practice for Emulsification/Suspension of Multiphase Fluid Waste Materials
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the generation of a single-phase suspension or emulsion from multiphase samples which are primarily liquid in order to facilitate sample preparation, transfer, and analysis.
1.2 This practice is designed to keep a multiphase fluid sample in an emulsified/suspended state long enough to take a single, composite sample that is representative of the sample as a whole. The sample may reform multiple layers after standing.
1.3 The emulsion/suspension generated by following this practice can be used only for analytical procedures designed for the total sample and procedures not significantly affected by the emulsifier or the presence of an emulsion/suspension.
1.4 This practice assumes that a representative sample of not more than one litre has been obtained.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
emulsification; heterogenous sample; multiphase; sample preparation
To find similar documents by ASTM Volume:
05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5761-96
Revision Level
1996 EDITION
Status
Superseded
Modification Type
New
Publication Date
April 10, 1996
Document Type
Practice
Page Count
4 pages
Committee Number
D02.03.0C