ASTM-D5799 › Historical Revision Information
Standard Test Method for Determination of Peroxides in Butadiene
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of peroxides in butadiene.
1.2 This test method covers the concentrations range of 1 to 10 ppm by mass (ppmw) as available oxygen.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
Due to the inherent danger of peroxides in butadiene, specification limits are usually set for their presence. This test method will provide values that can be used to determine the peroxide content of a sample of commercial butadiene.
Butadiene polyperoxide is a very dangerous product of the reaction between butadiene and oxygen that can occur. The peroxide has been reported to be the cause of some violent explosions in vessels that are used to store butadiene.
Keywords
butadiene; butadiene polyperoxide; peroxide; Butadiene (petroleum applications); Peroxides; Sampling petroleum products; ICS Number Code 71.080.10 (Aliphatic hydrocarbons)
To find similar documents by ASTM Volume:
05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)
To find similar documents by classification:
71.080.10 (Aliphatic hydrocarbons)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5799-95(2009)
Revision Level
1995 R09 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Dec. 1, 2009
Document Type
Test Method
Page Count
3 pages
Committee Number
D02.D0.04