ASTM-D5823 › Standard Test Method for Tuft Height of Pile Floor Coverings
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of tuft height using a grooved specimen holder. It applies to cut-pile and loop-pile floor covering after adhesive backing has been applied to bond the pile yarn to the backing fabric.
1.2 The values stated in SI units are to be regarded as the standard for all measurements. The inch-pound values are provided for information purposes only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
carpet; construction; pile yarn floor covering; tuft height; ICS Number Code 97.150 (Floor coverings)
To find similar documents by ASTM Volume:
07.02 (Textiles (II): D4393 - latest)
To find similar documents by classification:
59.080.60 (Textile floor coverings)
97.150 (Non-textile floor coverings Textile floor coverings, see 59.080.60)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5823-19R24
Revision Level
2019 R24 EDITION
Status
Current
Modification Type
Revision
Publication Date
Jan. 17, 2024
Document Type
Test Method
Page Count
4 pages
Committee Number
D13.21