Document Center is acquired by Nimonik

This specification covers the fabrication of new fully enclosed wire bound pallet-type wooden boxes intended for use as containers for domestic and overseas shipment of general materials and supplies, not exceeding a certain weight given. Wire bound pallet-type wooden box performance is dependent on its fabricated components; therefore, a variety of types, classes, and treatments reflecting varied performance are specified. According to type of material used in the manufacture of wooden boxes, four types are classified: Type I which are made with sheathed lumber, Type II which are made with sheathed lumber and veneer, Type III which are made of sheathed lumber and veneer with two different length sidewalls, and Type IV which are made of sheathed plywood. Four classes have been designated to wooden boxes, according to the number of entry ways: Class 1 which has partial four-way entry base, Class 2 which has two-way entry base, Class 3 which has partial four-way entry base with two different length sidewalls, and Class 4 which has two-way entry base with two different length sidewalls. And for the wooden boxes� last classification, the way they are treated are described also as follows: Treatment A and B- with water preservative treatment and Treatment C without preservative treatment. All recovered, recycled, or virgin materials used in box manufacture shall meet the requirements of this specification and referenced documents. In addition, materials shall not affect or be affected by the product being packed. To determine the wooden boxes� performance, the following tests shall be conducted: wood members moisture content test, coating adherence on galvanized wire test, wire tensile strength test, oxine copper preservative test, and zinc napthenate preservative test.