ASTM-D6325 › Historical Revision Information
Determining Open Assembly Time of Carpet Mastic Adhesives, Test Method For
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes a procedure to measure open assembly time for a troweled carpet adhesive.
1.2 This test method provides an evaluation of the ability of an adhesive to effectively wet out the intended carpet backing.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
adhesive; adhesion; carpet; open assembly time; ICS Number Code 59.080.60 (Textile floor coverings); 83.180 (Adhesives)
To find similar documents by ASTM Volume:
To find similar documents by classification:
59.080.60 (Textile floor coverings)
97.150 (Non-textile floor coverings Textile floor coverings, see 59.080.60)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6325-98
Revision Level
1998 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 10, 1998
Document Type
Test Method
Page Count
2 pages
Committee Number
D14.70