ASTM-D6325 Historical Revision Information
Determining Open Assembly Time of Carpet Mastic Adhesives, Test Method For

ASTM-D6325 - 1998 R11 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Determining Open Assembly Time of Carpet Mastic Adhesives
ORDER

Scope

1.1 This test method describes a procedure to measure open assembly time for a troweled carpet adhesive.

1.2 This test method provides an evaluation of the ability of an adhesive to effectively wet out the intended carpet backing.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

The ability to have a sufficient open assembly time is critical when bonding a carpet. An adhesive with too short an open assembly time will not allow the installer enough time to position the carpet before the adhesive is dried beyond use. A product with too long an open assembly time will not provide enough dry time for the carpet to bond to the intended substrate without movement of the carpet.

The test method provides a means of measuring the open assembly time for an adhesive. Use of such a test method can aid both the manufacturer to develop and the user to select the appropriate adhesive for the installation of carpet.

Test Method C679 was used as a model for this test method.

Keywords

adhesive; adhesion; carpet; open assembly time; Adhesives; Assembly time; Carpet adhesives; Mastic adhesives; Open assembly time; ICS Number Code 83.180 (Adhesives); 97.150 (Floor coverings)

To find similar documents by ASTM Volume:

15.06 (Adhesives)

To find similar documents by classification:

59.080.60 (Textile floor coverings)

83.180 (Adhesives Including adhesive tapes Adhesive tapes for electrical insulation purposes, see 29.035.20)

97.150 (Non-textile floor coverings Textile floor coverings, see 59.080.60)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D6325-98(2011)

Revision Level

1998 R11 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

Jan. 1, 2011

Document Type

Test Method

Page Count

2 pages

Committee Number

D14.70