ASTM-D6367 › Standard Specification for AMS (α-Methylstyrene)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification establishes the requirements for AMS (alpha-Methylstyrene). Sampled specimens shall conform to the following physical and chemical properties: minimum AMS content; maximum phenol content; maximum polymer content; inhibitor content; appearance; and color (Pt-Co units).
Scope
1.1 This specification covers AMS (α-Methylstyrene).
1.2 The following applies to all limits in this specification: for purposes of determining conformance with this specification, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 Consult current OSHA regulations, suppliers’ Safety Data Sheets, and local regulations for all materials used in this specification.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
α-Methylstyrene; AMS; catechol; TBC; tertiary-butyl catechol;
To find similar documents by ASTM Volume:
06.04 (Paint -- Solvents; Aromatic Hydrocarbons)
To find similar documents by classification:
75.080 (Petroleum products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6367-21
Revision Level
2021 EDITION
Status
Current
Modification Type
Revision
Publication Date
Nov. 30, 2021
Document Type
Specification
Page Count
2 pages
Committee Number
D16.07