ASTM-D6576 › Historical Revision Information
Standard Specification for Flexible Cellular Rubber Chemically Blown
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification establishes requirements for chemically blown cellular rubber.
1.2 In the case of conflict between the provisions of this specification and those of detailed specifications or test methods for a particular product, the latter shall take precedence.
1.3 Unless specifically stated otherwise, by agreement between the purchaser and the supplier, all test methods shall be performed in accordance with the test methods specified in this specification.
1.4 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.6 This specification and ISO 6916 are not equivalent.
Note 1--This specification was revised using the updated test methods and specification in Specification D1056 - 98.
Keywords
cellular; closed-cell; elastomeric; flexible; open cell; rubber; ICS Number Code 83.100 (Cellular materials)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6576
Revision Level
DOD ADOPTION
Status
Superseded
Modification Type
New
Publication Date
March 15, 2001
Document Type
Specification
Page Count
1 page
Committee Number
D20.22