Document Center is acquired by Nimonik

1.1 This guide is applicable for the selection of appropriate ASTM standard analytical methods for metallurgical processing sites to conform to International Cyanide Management Code guidance for the analysis of cyanide bearing solutions.

1.2 The analytical methods in this guide are recommended for the sampling preservation and analysis of total cyanide, available cyanide, weak acid dissociable cyanide, and free cyanide by Test Methods D2036, D4282, D4374, D6888, D6994, D7237, D7284, and D7511.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

5.1 This guide is intended as a means for selecting the proper methods for measuring cyanide to conform to the International Cyanide Management Code guidance related to the analysis of cyanide bearing solutions. Cyanide is analyzed in process solutions and in discharges in order to apply code guidance; however, improper sample collection and preservation can result in significant positive or negative bias, potentially resulting in over reporting or under reporting cyanide releases into the environment.

5.2 This guide contains comparative test methods that are intended for use in routine monitoring of cyanide. It is assumed that all who use methods listed in this guide will be trained analysts capable of performing them skillfully and safely. It is expected that work will be performed in a properly equipped laboratory applying appropriate quality control practices such as those described in Guide D3856.