ASTM-D952 › Historical Revision Information
Standard Test Method for Bond or Cohesive Strength of Sheet Plastics and Electrical Insulating Materials
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the bond strength or ply adhesion strength of sheet plastic and electrical insulating materials. It is applicable to both laminated and nonlaminated thermoplastic and thermosetting materials.
1.2 Test data obtained by this test method is relevant and appropriate for use in engineering design.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1—There is no known ISO equivalent to this standard.
Keywords
adhesive; bond strength; cohesive strength; interlaminar; intralaminar; laminated; plastics; ICS Number Code 83.140.10 (Films and sheets)
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
10.01 (Electrical Insulation (I): D69 - D2484)
To find similar documents by classification:
83.140.10 (Films and sheets Including plates)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D952-84
Revision Level
1984 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
July 27, 1984
Document Type
Test Method
Page Count
3 pages
Committee Number
D20.10