ASTM-D957 › Historical Revision Information
Standard Practice for Determining Surface Temperature of Molds for Plastics
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice is intended for determining the temperature at a specified point or points on the surface of the cavity and base of a mold for plastics. By determining the temperature at as many points as deemed necessary, the overall temperature condition of the surface can be determined.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are given for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1--There is no similar ISO standard.
Keywords
base; cavity; mold temperature; pyrometer; ICS Number Code 83.200
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
To find similar documents by classification:
83.200 (Equipment for the rubber and plastics industries)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D957-95(2000)e1
Revision Level
1995 R00(E1) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Nov. 1, 2000
Document Type
Practice
Page Count
2 pages
Committee Number
D20.09