ASTM-E1025 › Historical Revision Information
Standard Practice for Design, Manufacture, and Material Grouping Classification of Hole-Type Image Quality Indicators (IQI) Used for Radiology
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the design, material grouping classification, and manufacture of hole-type image quality indicators (IQI) used to indicate the quality of radiologic images.
1.2 This practice is applicable to X-ray and gamma-ray radiology.
1.3 The values stated in inch-pound units are to be regarded as standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Classification; Design-radiology; Gamma radiation; IQI (image quality indicators); Radiographic testing; Radiological examination; X-irradiation; X-ray monitoring; hole-type image quality indicators (IQI) for; radiology-design/manufacture/material grouping classification,; practice,; Image analysis-radiographic testing; hole-type image quality indicators(IQI) for; radiology-design/manufacture/material grouping classification,; practice; ICS Number Code 19.100 (Non-destructive testing)
To find similar documents by ASTM Volume:
03.03 (Nondestructive Testing)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E1025-98
Revision Level
1998 EDITION
Status
Superseded
Publication Date
July 10, 1998
Document Type
Practice
Page Count
6 pages
Committee Number
E07.01