Document Center is acquired by Nimonik

Scope

1.1 This test method is for measuring the throughput, or mass flowrate, of a resource-recovery unit operation, or series of unit operations.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.2.1 Exception—Section 9.1.2 indicates the equivalent weight in pounds for samples with particle size greater than 90 mm.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary information is given in Section 7.

Significance and Use

This test method is used to document the mass flowrate of a resource recovery unit operation in a plant and as a means of relating operation to design objectives.

This test method is also used in conjunction with measurements of the performance of materials separators (particularly recovery and purity). As such, throughput should not generally be measured by sampling the feed since this may change its performance. Processing equipment that does not perform separations can be sampled at either the feed or product streams.

Keywords

Binary separator; Flow and flow rate--environmental studies; Materials separation; Output streams; Polynary separator; Process stream analysis; Refuse-derived fuel (RDF); Sampling waste materials/applications; Sediment; Throughput

To find similar documents by ASTM Volume:

11.04 (Waste Management)

To find similar documents by classification:

03.100.50 (Production. Production management)

13.030.50 (Recycling Including relevant equipment Motor vehicle recycling, see 43.020)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.