ASTM-E111 › Historical Revision Information
Standard Test Method for Young's Modulus, Tangent Modulus, and Chord Modulus
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of Young's modulus, tangent modulus, and chord modulus of structural materials. This test method is limited to materials in which and to temperatures and stresses at which creep is negligible compared to the strain produced immediately upon loading and to elastic behavior.
1.2 Because of experimental problems associated with the establishment of the origin of the stress-strain curve described in 8.1, the use of either initial tangent modulus (that is, the slope of the stress-strain curve at the origin) or secant modulus is not recommended and their determination is outside the scope of this test method.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
chord modulus; elasticity; elastic modulus; tangent modulus; tensile test; Young's modulus; ICS Number Code 19.060 (Mechanical testing)
To find similar documents by ASTM Volume:
03.01 (Metals -- Mechanical Testing; Elevated and Low-Temperature Tests; Metallography)
To find similar documents by classification:
19.060 (Mechanical testing Including testing equipment Mechanical testing of metals, see 77.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E111-82(1996)e1
Revision Level
1982 R96(E1) EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Nov. 1, 1996
Document Type
Test Method
Page Count
6 pages
Committee Number
E28.03