Document Center is acquired by Nimonik

Scope

1.1 This practice lists the physical requirements that an impact machine shall meet in order to be registered as a reference machine.

1.2 This practice describes the procedure by which a reference machine shall be qualified to make tests to establish reference values.

1.3 These requirements and procedures are not intended to be applied to impact machines and testing procedures used for purposes other than to qualify machines for the determination of reference values of verification specimens.

1.4 This practice does not describe the procedure by which the reference value for a specified reference material is determined. The procedure varies with the material being tested and is to be found in different standards for various specified verification materials.

1.5 Values stated in inch-pound units are to be regarded as the standard. SI units are given for information only.

1.6 This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Charpy impact test; Environmental control/fate; Impact testing-Charpy; Interlaboratory testing; Reference machines; Specified verification material; Verification; qualifying charpy impact machines as reference machines, practice; ICS Number Code 19.060 (Mechanical testing)

To find similar documents by ASTM Volume:

03.01 (Metals -- Mechanical Testing; Elevated and Low-Temperature Tests; Metallography)

To find similar documents by classification:

19.060 (Mechanical testing Including testing equipment Mechanical testing of metals, see 77.040.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in Paper format.