ASTM-E1351 › Historical Revision Information
Standard Practice for Production and Evaluation of Field Metallographic Replicas
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers recognized methods for the preparation and evaluation of cellulose acetate or plastic film replicas which have been obtained from metallographically prepared surfaces. It is designed for the evaluation of the metallographic replica to ensure that all significant features of a metallographically prepared surface have been duplicated and preserved on the replica with sufficient detail to permit both LM and SEM examination with optimum resolution and sensitivity.
1.2 This practice may be used as a controlling document in commercial situations.
1.3 The values stated in SI units are to be regarded as the standard. Inch-pound units given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
replica; replication
To find similar documents by ASTM Volume:
03.01 (Metals -- Mechanical Testing; Elevated and Low-Temperature Tests; Metallography)
To find similar documents by classification:
77.040.99 (Other methods of testing of metals)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E1351-01
Revision Level
2001 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 10, 2001
Document Type
Practice
Page Count
6 pages
Committee Number
E04.01