ASTM-E1412 › Historical Revision Information
Standard Practice for Separation of Ignitable Liquid Residues from Fire Debris Samples by Passive Headspace Concentration With Activated Charcoal
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the procedure for removing small quantities of ignitable liquid residue from samples of fire debris using an adsorbent material to extract the residue from the static headspace above the sample, then eluting the adsorbent with a solvent.
1.2 While this practice is suitable for successfully extracting ignitable liquid residues over the entire range of concentration, the headspace concentration methods are best used when a high level of sensitivity is required due to a very low concentration of ignitable liquid residues in the sample.
1.2.1 Unlike other methods of separation and concentration, this practice is essentially nondestructive.
1.3 Alternate separation and concentration procedures are listed in the referenced documents. (see Practices E 1385, E 1386, E 1388, and E 1413).
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This practice is useful for preparing extracts from fire debris for later analysis by gas chromatography, GC/MS, or GC/IR.
This is a very sensitive separation procedure, capable of isolating quantities smaller than 1/10 μL of ignitable liquid residue from a sample.
Keywords
fire debris samples; passive headspace concentration; ICS Number Code 13.220.99 (Other standards related to fire protection)
To find similar documents by ASTM Volume:
To find similar documents by classification:
13.220.99 (Other standards related to protection against fire)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E1412-07
Revision Level
2007 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 15, 2007
Document Type
Practice
Page Count
2 pages
Committee Number
E30.01