ASTM-E1867 › Historical Revision Information
Standard Test Method for Temperature Calibration of Dynamic Mechanical Analyzers
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers methods for the temperature calibration of dynamic mechanical analyzers (DMA) from -150 to 500°C.
1.2 Electronic instrumentation or automated data analysis and reduction systems or treatments equivalent to this method may be used.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Note 7.
Keywords
calibration; dynamic mechanical analyzer; temperature; thermal analysis; ICS Number Code 17.200.20 (Temperature-measuring instruments)
To find similar documents by ASTM Volume:
14.01 (Healthcare Informatics)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E1867-97
Revision Level
1997 EDITION
Status
Superseded
Modification Type
New
Publication Date
March 10, 1997
Document Type
Test Method
Page Count
4 pages
Committee Number
E37.10