ASTM-E1944 › Historical Revision Information
Standard Practice for Describing and Measuring Performance of Laboratory Fourier Transform Near-Infrared (FT-NIR) Spectrometers: Level Zero and Level One Tests
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers two levels of tests to measure the performance of laboratory Fourier transform near infrared (FT-NIR) spectrometers. This practice applies to the short-wave near infrared region, approximately 800 mm (12 500 cm-1) to 1100 mm (9090.91 cm-1); and the long-wavelength near infrared region, approximately 1100 mm (9090.91 cm-1) to 2500 mm (4000 cm-1). This practice is intended mainly for transmittance measurements of gases and liquids, although it is broadly applicable for reflectance measurements.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
calibration test; FT-NIR; Fourier transform near infrared; level one test; level zero test; performance test; spectrometers
To find similar documents by ASTM Volume:
03.06 (Molecular Spectroscopy; Surface Analysis)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E1944-98
Revision Level
1998 EDITION
Status
Superseded
Modification Type
New
Publication Date
March 10, 1998
Document Type
Practice
Page Count
5 pages
Committee Number
E13.03