ASTM-E2001 › Historical Revision Information
Standard Guide for Resonant Ultrasound Spectroscopy for Defect Detection in Both Metallic and Non-Metallic Parts
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This guide describes a procedure for detecting defects in metallic and non-metallic parts using the resonant ultrasound spectroscopy method. The procedure is intended for use with instruments capable of exciting and recording whole body resonant states within parts which exhibit acoustical or ultrasonic ringing. It is used to distinguish acceptable parts from those containing defects, such as cracks, voids, chips, density defects, tempering changes, and dimensional variations that are closely correlated with the parts' mechanical system dynamic response.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
The primary advantage of RUS is its ability of making numerous measurements in a single test. In addition, it can examine rough ground parts. It requires little sample preparation, no couplants, and generally will work with soiled items; however, it has no capability with soft materials. Soft metals, polymers, rubbers, and wood parts are not viable candidates for this technology.
Keywords
acoustic resonance spectroscopy; elastic properties; impulse excitation; modes; nondestructive test; peak shifting; peak splitting; quality control; resonance inspection; resonance ultrasound spectroscopy; resonances; resonant acoustic method; swept sine excitation; Acoustic resonance spectroscopy; Defects--metals/alloys; Elastic properties; Metals and metallic materials; Nondestructive evaluation (NDE)--radiographic; Nonmetallic materials; Peak shifting and quality control; Resonance inspection; Resonant ultrasound spectroscopy; ICS Number Code 19.100 (Non-destructive testing)
To find similar documents by ASTM Volume:
03.03 (Nondestructive Testing)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E2001-08
Revision Level
2008 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
July 1, 2008
Document Type
Guide
Page Count
8 pages
Committee Number
E07.06