ASTM-E2109 › Historical Revision Information
Test Methods for Determining Area Percentage Porosity in Thermal Sprayed Coatings
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover procedures to perform porosity ratings on metallographic specimens of thermal sprayed coatings (TSCs) prepared in accordance with Guide E 1920 by direct comparison to standard images and via the use of automatic image analysis equipment.
1.2 These test methods deal only with recommended measuring methods and nothing in them should be construed as defining or establishing limits of acceptability for any measured value of porosity.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
area fraction; automatic image analysis; porosity; TSCs; ICS Number Code 25.220.20 (Surface treatment)
To find similar documents by ASTM Volume:
03.01 (Metals -- Mechanical Testing; Elevated and Low-Temperature Tests; Metallography)
To find similar documents by classification:
25.220.20 (Surface treatment Including anodization, conversion coating, thermal spraying, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E2109-01(2007)
Revision Level
2001 R07 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 1, 2007
Document Type
Test Method
Page Count
8 pages
Committee Number
E04.14