ASTM-E2402 Historical Revision Information
Standard Test Method for Mass Loss and Residue Measurement Validation of Thermogravimetric Analyzers

ASTM-E2402 - 2005 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Mass Loss, Residue, and Temperature Measurement Validation of Thermogravimetric Analyzers
ORDER

Scope

1.1 This method provides procedures for validating mass loss and residue measurements by thermogravimetric analyzers (TGA) and analytical methods based upon the measurement of mass loss or residue content. Performance parameters determined include mass loss and residue repeatability (precision), detection limit, quantitation limit, linearity and bias.

1.2 Validation of apparatus performance and analytical methods is requested or required for quality initiatives or where results may be used for legal purposes.

1.3 SI units are the standard.

1.4 There is no ISO standard equivalent to this method.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This method may be used to validate the performance of a specific TGA apparatus.

This method may be used to validate the performance of a specific method based upon a TGA mass loss or residue measurement.

This method may be used to determine the repeatability of a specific apparatus, operator or laboratory.

This method may be used for specification and regulatory compliance purposes.

Keywords

detection limit; linearity; precision; quantitation limit; range; repeatability; thermal analysis; thermogravimetric analysis; validation; ICS Number Code 19.020 (Test conditions and procedures in general); 71.040.10 (Chemical laboratories. Laboratory equipment)

To find similar documents by ASTM Volume:

14.02 (General Test Methods; Forensic Psychophysiology; Forensic Sciences; Terminology; Conformity Assessment; Statistical Methods; Nanotechnology; Forensic Engineering; Manufacture of Pharmaceutical Products)

To find similar documents by classification:

19.020 (Test conditions and procedures in general)

71.040.10 (Chemical laboratories. Laboratory equipment Including hydrometers, alcoholometers, etc. Apparatus for measurement of volume, mass, density, viscosity, see 17.060 Spectroscopes, see 17.180.30 Temperature-measuring instruments, see 17.200.20 Laboratory ware, see 71.040.20)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-E2402-05

Revision Level

2005 EDITION

Status

Superseded

Modification Type

New

Publication Date

Jan. 1, 2005

Document Type

Test Method

Page Count

5 pages

Committee Number

E37.10