ASTM-E2631 › Historical Revision Information
Standard Practice for Physical Placement of an Entity-Controlled Supplemental Identification Label
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice is for supplemental identification labels assigned by an entity and affixed to equipment to permit control.
1.2 Identifying labels include, but are not limited to, removable tags, bands, and plates.
1.3 This practice is not intended for material or manufacturer’s warranties.
1.4 This practice is not intended for original equipment manufacturer’s (OEM’s) markings.
1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
FIG. 1 Entity Identification Labels Facing the User
FIG. 2 Entity Identification Label Placed on Front Right Side of the Equipment
FIG. 3 Entity Identification Label Attached to Tool
Significance and Use
There is no consistent method for the physical placement of an identifying label on equipment in the possession of an entity.
This practice is intended to expedite and improve the physical inventory and self-assessment processes and other occasions in which the instant identification of equipment is needed for purposes of control, management, or determining ownership, or a combination thereof.
The further intent of this practice is to reduce the administrative costs associated with activities requiring equipment identification, that is, physical inventory, self-assessments, and audits and to supplement Practice E 2279
Keywords
entity; equipment; identification label; placement; tag; ICS Number Code 01.080.99 (Other graphical symbols); 55.020 (Packaging and distibution of goods in general)
To find similar documents by ASTM Volume:
To find similar documents by classification:
01.080.99 (Other graphical symbols)
55.020 (Packaging and distribution of goods in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E2631-09
Revision Level
2009 EDITION
Status
Superseded
Modification Type
New
Publication Date
Aug. 1, 2009
Document Type
Practice
Page Count
3 pages
Committee Number
E53.01