ASTM-E405 › Historical Revision Information
Standard Test Methods for Wear Testing Rotary Operators for Windows
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods describe the wear testing of gear-type rotary operating devices used for opening and closing windows (Note 1).
1.2 These test methods do not directly determine the effects of varying environmental conditions but may be employed after environmental exposure to evaluate the effect of such exposure.
1.3 These test methods are not intended to evaluate the structural adequacy of the operator in resisting the maximum force to which it may be subjected.
Note 1-Certain types of rotary window operators, such as torque-bar operators and telescopic operators cannot be tested by these test methods.
1.4 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units may be approximate.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Note 3.
Keywords
rotary operators; rotary windows; wear testing; windows; ICS Number Code 91.060.50 (Doors and windows)
To find similar documents by ASTM Volume:
04.11 (Building Constructions (I): E72 - E2110)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E405-89
Revision Level
1989 EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Feb. 24, 1989
Document Type
Test Method
Page Count
4 pages
Committee Number
E06.51