ASTM-F1179 › Historical Revision Information
Standard Practice for Inspection Procedure for Use of Anaerobic Thread Locking Compounds with Studs
The following bibliographic material is provided to assist you with your purchasing decision:
This practice covers an inspection procedure to ensure that studs installed with an anaerobic thread locking compound have achieved the necessary backout resistance. Verification of fastener locking effectiveness of anaerobic compounds shall be done. After inspection, the joint assembly shall be completed and final torque applied.
Scope
1.1 This practice covers an inspection procedure to ensure that studs installed with an anaerobic thread locking compound have achieved the necessary backout resistance.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
anaerobic compound; inspection; locking threaded fastener
To find similar documents by ASTM Volume:
01.07 (Ships and Marine Technology)
To find similar documents by classification:
21.060.10 (Bolts, screws, studs)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1179-88(2014)
Revision Level
1988 R14 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
March 15, 2014
Document Type
Practice
Page Count
2 pages
Committee Number
F25.07